Omnibus F3 Pro V2 Flight Controller - Betaflight OSD

Sold Out

New V2 that has the 24a issue fixed

The flip32 Omnibus flight controller uses the MPU6000 over SPI for the best possible flight performance. Along with the MPU6000 and an AB7456 OSD chip (an upgraded MAX7456) for the BetaFlight integrated OSD. You won't need a PDB with this build because there is a high performance 5v, 1.5a STMicrocontroller L78 voltage regulator, so you can plug the flight battery right into the flight controller.The  Omnibus flight controller the frist  F3 flight controller with a MAX7456 OSD chip directly connected to the flight controller, so it can be configured from the BetaFlight configurator.  
This flight controller requires BetaFlight 3.0 & Betaflight configurator to take full advantage of the OSD

The Pro Also Includes a current sensor to Measure your current used - more important than voltage to most pilots !



STM32 F303 MCU, Runs Betaflight 3.0 firmware

SBUS/PPM input (Pinheaders)

8PWM output (1-4Pinheaders and Sh1.0 Plug, 5-6 as Pinheaders)

Only 36x36mm, mount holes 30.5x30.5mm

128Mb Flash(16M Byte)IR Pins for race timing transponder

SPI Sensor MPU6000

SD Card slot


2-5S Lipo Direct power

The Omnibus has an SDCard for blackbox logging and uses the much faster VCP USB link, so it takes minutes instead of hours to copy your blackbox logs off the flight controller.


SKU 1155
Shipping Weight 0.0250kg

Be The First To Review This Product!

Help other Buzz Hobbies users shop smarter by writing reviews for products you have purchased.

Write a product review

Others Also Bought

More From This Category