Module quadcopter building has never looked this good. Use the clean build cover to hide the bundles of wires in your FPV setup.
The cover to fit inside the Hoverthings FPV Pro and Pro-Gimbal version frames.
To leave as much room as possible, the cover is molded around the standoffs.
The cover is left undrilled so you may put the holes for venting and running wires where you want them.
Made from a High Impact ABS Plastic As you will notice in the photos there is a small gap between the top plate and the cover. This is to provide room for ventilation.
You can drill holes before installing in the areas the top plate covers up so you still get a clean look but ports for venting.
Use nylon nuts as spacers or rubber washers. I use nylon screws to hold the cover in place, nylon nuts for spacers, then a nylon nut on the inside of the cover to keep it tight and it lifts up with the top plate.
100% Made in the USA
Be The First To Review This Product!
Help other Buzz Hobbies users shop smarter by writing reviews for products you have purchased.